The Brick-yard Homepage Brickwerks
Forum Home Forum Home > T3 Section > T3 Tech help
  New Posts New Posts RSS Feed - Help changing diff bearings
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Help changing diff bearings

 Post Reply Post Reply
Author
Message
Neil.T View Drop Down
Newbie
Newbie


Joined: 05 Dec 19
Location: Manchester
Status: Offline
Points: 3
Post Options Post Options   Thanks (0) Thanks(0)   Quote Neil.T Quote  Post ReplyReply Direct Link To This Post Topic: Help changing diff bearings
    Posted: 12 Feb 20 at 23:49
Hello .

I need a bit of information of a gearbox issue .
I've built several engines , and done all mechanical and body repairs to cars and vans I've owned .
But I've never worked on a gearbox .

I'm having a problem with my gearbox , at first I thought it was the CV joint gone against the gearbox as it started making the same noise as the one on the other side did a few years back .
Turns out there was a bit of play in it , but when I undid the bolts to swap it I found the output shaft and flange had a lot of play to them .
Clearly the diff bearing needs replacing .

.
But that thread is about dismantling and rebuilding a gearbox with all the adjustments that goes with it.
.
Now I can take off  the flange and remove the  side adjuster , I can have someone remove the old bearing in a press , and I can fit in the new bearing .
.
My question is , how far/tight do I refit the side adjuster ?
Is it just a case if marking the side adjuster and gearbox body before disassembly and refitting to the same position ?
Is it fine to tighten to a certain torque ?
.
Or do I need to drop the box and take it to a transmission specialist ?

Thanks in advance .



Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.01
Copyright ©2001-2018 Web Wiz Ltd.

The WebThis site