DIY Re-Furbing |
Post Reply |
Author | |
strangely brown
Yardie Joined: 26 Mar 05 Location: Jersey Status: Offline Points: 321 |
Post Options
Thanks(0)
Posted: 18 Mar 09 at 20:26 |
Hi to all, i am going to re-furb the slight de-lamination on the newly brought/drilled alloys i have got, the delamination is only on the polished/laminated part especially around the stud-holes. So what i am going to do is get the lacquer of off the raised area with a rubber block and wet and dry to get down to the alloy, so as to keep the original lines,then mask-up the area.
Etch-prime it, apply a coat of primer, then colour, after this i am going to re-mask just outside the area and apply a coat or two of lacquer. Am i on the right road, does anyone have any thoughts on the subject.
any replies greatly appreciated
S.B.
|
|
strangely brown (colonial cousin)
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |