overhaul parts needed |
Post Reply | Page <12 |
Author | |
marlinowner
Not Quite Newbie Joined: 18 Mar 14 Location: Scottish Border Status: Offline Points: 33 |
Post Options
Thanks(0)
|
The clutch parts are specific to the South African T3s, an Audi 240mm clutch with 24 splines will fit eg LUK 624083900 (Audi 200 2.1) but on the original clutch friction plate the centre boss is offset towards the gearbox - this means that the LUK kit (or other off the shelf clutches) will not fully engage on the input shaft splines.
I think many people use the Audi clutch kit with no problems, I had my original clutch refurbished but don't know if that route is open to you. |
|
monkslayer
Not Quite Newbie Joined: 01 Jan 17 Location: Nairobi Status: Offline Points: 35 |
Post Options
Thanks(0)
|
Thank you marliinowner. Will have a look see if i can find the part number given. if not will go the audi route and see how that works out. If you and other have gone that route with minimal issues then i guess why not!;-)
I also have been checking for the rotor and distributor cap for it. The ones i see online seem a bit different. Do you have the part numbers for this too? Cheers |
|
MONK
|
|
monkslayer
Not Quite Newbie Joined: 01 Jan 17 Location: Nairobi Status: Offline Points: 35 |
Post Options
Thanks(0)
|
just to confirm...will the kit as it is work? i.e the clutch friction plate,pressure plate and even the release bearing?
*apologies for what may seem a silly question Cheers. |
|
MONK
|
|
marlinowner
Not Quite Newbie Joined: 18 Mar 14 Location: Scottish Border Status: Offline Points: 33 |
Post Options
Thanks(0)
|
I'm using BERU VK385S, VW 034905207B, distributor cap, and Beru 0300900096 (rev limited) rotor arm as that was what was already fitted.
Original rotor arm is 052905225C which is used on loads of VWs. |
|
marlinowner
Not Quite Newbie Joined: 18 Mar 14 Location: Scottish Border Status: Offline Points: 33 |
Post Options
Thanks(0)
|
Clutch kit will work but friction plate will not fully engage with input shaft.
|
|
monkslayer
Not Quite Newbie Joined: 01 Jan 17 Location: Nairobi Status: Offline Points: 35 |
Post Options
Thanks(0)
|
cool..got it. I guess in a nutshell,from the LUK kit:
Cheers |
|
MONK
|
|
marlinowner
Not Quite Newbie Joined: 18 Mar 14 Location: Scottish Border Status: Offline Points: 33 |
Post Options
Thanks(0)
|
http://www.oemepc.com is a good source of part numbers, selecting ZA and typ2 1995, although 2.5 engine is not covered - most parts are the same as 1995 2.3/2.6 although not front brakes and rear driveshafts (i think).
|
|
monkslayer
Not Quite Newbie Joined: 01 Jan 17 Location: Nairobi Status: Offline Points: 35 |
Post Options
Thanks(0)
|
Cheers marlinowner. You have been quite helpful!Thank you for clearing the newbie questions!
Much appreciated. |
|
MONK
|
|
mucho
Groupie Joined: 07 Dec 11 Location: Nairobi, Kenya Status: Offline Points: 51 |
Post Options
Thanks(0)
|
Hi Monk, welcome aboard, nice to have a fellow Kenyan on these boards. If you are still on the hunt for the original clutch plate, the part number is 22S 141 031 A. Good luck.
|
|
2.6i Caravelle 1997 powered by Audi 5 Cylinder - Motronic
|
|
monkslayer
Not Quite Newbie Joined: 01 Jan 17 Location: Nairobi Status: Offline Points: 35 |
Post Options
Thanks(0)
|
Hey,
That's awesome news. Yes got the original part numbers. Now only to find them......any leads on the original clutch plate locally will be appreciated. Cheers |
|
MONK
|
|
monkslayer
Not Quite Newbie Joined: 01 Jan 17 Location: Nairobi Status: Offline Points: 35 |
Post Options
Thanks(0)
|
Hello guys,
Does anyone know the part number for the nozzle seals at the cylinder jead for engines that use the CIS injection system? Can't seem to find them on oempc.com , since they show the catalog for the EFI engine. Thank you in advnance. |
|
MONK
|
|
marlinowner
Not Quite Newbie Joined: 18 Mar 14 Location: Scottish Border Status: Offline Points: 33 |
Post Options
Thanks(0)
|
For fuel injection parts for the 2.5 engine,look at 80's Audi 5 cylinder parts, eg
http://www.oemepc.com/audi/part_single/catalog/au/markt/RDW/modell/A200/year/1988/drive_standart/87/hg_ug/133/subcategory/37035/part_id/253757/lang/e |
|
monkslayer
Not Quite Newbie Joined: 01 Jan 17 Location: Nairobi Status: Offline Points: 35 |
Post Options
Thanks(0)
|
Cheers
|
|
MONK
|
|
Post Reply | Page <12 |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |