The Brick-yard Homepage Brickwerks
Forum Home Forum Home > T3 Section > T3 Wheel help
  New Posts New Posts RSS Feed - 17“ BBS RS replicas
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

17“ BBS RS replicas

 Post Reply Post Reply
Author
Message
toolkit View Drop Down
Not Quite Newbie
Not Quite Newbie
Avatar

Joined: 18 Nov 09
Location: Zagreb, Croatia
Status: Offline
Points: 17
Post Options Post Options   Thanks (0) Thanks(0)   Quote toolkit Quote  Post ReplyReply Direct Link To This Post Topic: 17“ BBS RS replicas
    Posted: 09 Jan 16 at 19:17
I'm planning to buy some Japan Racing wheels BBS RS replicas.
17x8.5 et20 front and back, or maybe 17x10 et 20 for the back if they fit.

My van is 1982 2wd.
The van is not lowered yet, but it will be -50mm

I don't have a problem with sticking out slightly , as I'm planning  to do full bodywork, so I can roll out arches a bit. I know i'll need to extend slider.
Searching around I see that 18x8.5 et20 works quite well, but does seventeens make the diference for contact with upper arm?

So 17x8.5 et20 front and back will they fit?
And maybe 17x10 et20 for the back?


Thanx  and sorry for the long post!

Back to Top
booted View Drop Down
Vanorak
Vanorak
Avatar

Joined: 13 May 07
Location: Luton
Status: Offline
Points: 2671
Post Options Post Options   Thanks (0) Thanks(0)   Quote booted Quote  Post ReplyReply Direct Link To This Post Posted: 10 Jan 16 at 16:24
Wont fit off set is too low they will stick out about 20 mm past the arches
Back to Top
toolkit View Drop Down
Not Quite Newbie
Not Quite Newbie
Avatar

Joined: 18 Nov 09
Location: Zagreb, Croatia
Status: Offline
Points: 17
Post Options Post Options   Thanks (0) Thanks(0)   Quote toolkit Quote  Post ReplyReply Direct Link To This Post Posted: 10 Jan 16 at 18:28
I was afraid of that.. 2cm is alot... 
tnx!
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.06
Copyright ©2001-2023 Web Wiz Ltd.

The WebThis site